ISO 15524:2011 pdf download.Pneumatic fluid power -Cylinders —Single-rod short-stroke cylinders,1 000 kPa (10 bar) series, bores from 20 mm to 100 mm
ISO 15524 establishes a metric series of single-rod pneumatic short-stroke cylinders with bores from 20 mm to 100mm (inclusive) for use at maximum working pressure of 1 000 kPa [10 bar] with and without magnetic function. They are not equipped with adjustable cushioning. so their application is restricted to those systems where adlustable cushioning is not required.
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 3320, Fluid power systems and components — Cylinder bores and piston rod diameters — Metric serres
ISO 4393, Fluid power systems end components — Cylinders — Basic sones of piston strokes
ISO 5598, Flutd power systems end components — Vocabulary
ISO 6099, Fluid power systems and components — Cylinders — ldentificatkin code for mounting dimens,ions and mounting types
ISO 16030. Pneumatic fluid power — Connections — Ports and stud ends
3 Terms and definitions
For the purposes of this document, the terms and de(ln,tlons given In ISO 5598 apply.
4 Bore sizes
Cylinders with the following bore sizes. .•f I., expressed in millimetres, are included in this series, in accordance with ISO 3320:
20.-25—32.-40—50—63—80--100
S Nominal stroke
5.1 The nominal strokes shall be selected from the recommended values given in ISO 4393, as shown in
Figure 1 The maximum stroke length should not exceed 100 mm.
5.2 The nominal stroke tolerances are given in Table 1.
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 3320, Fluid power systems and components — Cylinder bores and piston rod diameters — Metric serres
ISO 4393, Fluid power systems end components — Cylinders — Basic sones of piston strokes
ISO 5598, Flutd power systems end components — Vocabulary
ISO 6099, Fluid power systems and components — Cylinders — ldentificatkin code for mounting dimens,ions and mounting types
ISO 16030. Pneumatic fluid power — Connections — Ports and stud ends
3 Terms and definitions
For the purposes of this document, the terms and de(ln,tlons given In ISO 5598 apply.
4 Bore sizes
Cylinders with the following bore sizes. .•f I., expressed in millimetres, are included in this series, in accordance with ISO 3320:
20.-25—32.-40—50—63—80--100
S Nominal stroke
5.1 The nominal strokes shall be selected from the recommended values given in ISO 4393, as shown in
Figure 1 The maximum stroke length should not exceed 100 mm.
5.2 The nominal stroke tolerances are given in Table 1.
